- If you are not yet a Down To Earth subscriber, please click here to subscribe: Subscription
- If you are an existing Down To Earth subscriber, please log in to download digital archives.
Blood test made easy with paper and adhesive tapes
TESTING of blood for iron, glucose and protein levels is a time-consuming and costly affair requiring a series of chemical tests in a laboratory. Researchers from the Harvard University in US invented a device called the 3D PAD that could do away with the requirement of a laboratory analysis.
The device is portable and can be used to test various constituents of blood simultaneously. Even urine samples can be analyzed this way.
The researchers arranged vertical stacks of patterned paper with alternating water impermeable double-sided adhesive tapes. The arrangement was such that between each two layers of paper there was a layer of adhesive tape creating a three-dimensional network of paper-tape-paper and so on.
The topmost layer of paper had inlets for collecting fluid samples of blood or urine. The inlets led to corresponding openings in the layer of adhesive tape below it. The subsequent layer of paper had channels etched into it which distributed fluids from each inlet into further channels. These channels ended in a complex array of detection spots in the lowest stack of paper. Each layer of tape had openings to allow for flow of fluids without letting them mix.
"Imagine a tank with four channels leading out of it, and each channel then breaks up into four smaller channels, and each smaller channel leads to a smaller tank. When you add fluid to the first tank, it will be distributed through the network of channels into the 16 smaller tanks. We are doing something similar, but on a microscale, and all on paper," explained Andrez Martinez, one of the researchers who contributed to the technology that was published in the December 16 issue of the Journal Proceedings of the National Academy of Sciences.
In this case, the network of channels drew each fluid by capillary action from its inlet at the top, distributing it into the corresponding detection spots below. The inlets, the detection spots and the channels connecting them were etched by impregnating the paper with photoresist (a light sensitive polymer).
Constituent-specific reagents at the detection spots reacted with the constituents of each fluid simultaneously. The device had a control sample as one of the fluids. This helped in analyzing the concentration of each constituent by comparing its colour (after reaction with its reagent) with the colour of that of the control sample. Hence detection of difference in concentrations was easy.
This technology can make up for detection in places where the doctor can't reach on time. Depending on the number of inlets, one device can test blood or urine samples of the entire family. The more the number of detection spots (which can be increased by increasing the stacks of paper), the more the number of constituents to be tested.
One-dimensional paper-based detection devices are used in environmental monitoring, but can test limited number of constituents. In 3D PADs this limitation can be taken care of by increasing the number of stacks of paper.
We are a voice to you; you have been a support to us. Together we build journalism that is independent, credible and fearless. You can further help us by making a donation. This will mean a lot for our ability to bring you news, perspectives and analysis from the ground so that we can make change together.
Comments are moderated and will be published only after the site moderator’s approval. Please use a genuine email ID and provide your name. Selected comments may also be used in the ‘Letters’ section of the Down To Earth print edition.